Access tailored services, 24/7 self-service and expert help. Anywhere, anytime, any project.Discover now
Schneider Electric Canada Website×
Explore our global offerings or select your country from one of our five regions.Global
Découvrez nos offres globales ou sélectionnez votre pays dans l’une de nos cinq régions.
State of the R1 relay.
Altistart 48, ATS48
All models and serial numbers
Programming or other conditions.
Make sure R1 is assigned as R1F. R1F is the default setting for the R1 relay. If it has been changed to R1I the relay will not change state until a run command is issued to the soft start.
The programming of the R1 relay can be found in menu I/O.
Check and make sure that automat restart feature is not turned on under PRO menu. ATS should be set to no. If unit faults out it will not allow the fault relay to change state anthill the unit has gone through automatic restart phase.
Do a factory reset. Go to DRC and find FCS parameter. Set it to yes and hold enter for 3 seconds.