Technical FAQs

Ask a Question

What is needed to program a TeSys T overload relay?

Product Line: 
TeSys T Motor Management System

Resolution: 
In order to initially program the TeSys T device you will either need the handheld programmer and a 2 x RJ45 cable, or the somove software installed on your laptop and a modbus serial cable. The part numbers and downloads for these two separate options are listed below. 

There is also programming available via the various communications protocols once communication has been established to the device. 


Option 1: 
Handheld programmer part number: LTMCU 
Handheld programmer cable part number: VW3A1104R10 

Option 2: 
Modbus serial cable part number: TCSMCNAM3M002P 
SoMove software download: http://www.schneider-electric.us/en/product-range-download/2714-somove 
TeSys DTM Library download: http://www.schneider-electric.us/en/product-range-download/2714-somove 



KEYWORDS: 
LTMR, LTMR27, LTMR100, LTMR08, TeSys T, SSOLR
Was this helpful?
What can we do to improve the information ?