Technical FAQs

Ask a Question

Configuring Ethernet Communications on Scadapack 535E


The following procedure describes how to configure an Ethernet communications link between Eth1 on the rPAC and the SCADAPack E Configurator computer.
To Configure an Ethernet Communications Link

  1. Plug the Usb cable from the computer to the USB port of the scadapack 535E to write configurations.
  2. Using a CAT5 UTP cable, connect Eth1 on the rPAC to a switch, a hub, or a wall outlet for your LAN.
  3. Confirm that the SCADAPack E Configurator computer is also connected to the LAN.
  4. If the SCADAPack E Configurator software is not already running, launch it by selecting Start > All Programs > Schneider Electric > SCADAPack E > SCADAPack E Configurator and choosing your rPAC.

  5. The SCADAPack E Configurator main window opens as shown below.

  6.  

SCADAPack E Configurator Main Window
  1. In the SCADAPack E Configurator software, expand the TCP/IP folder then select the TCP/IP property page.

SCADAPack E Configurator TCP/IP Property Page
  1. Enter the IP Address and Subnet Mask obtained from your network administrator.
  2. Then Write the configuration to the RTU and wait for the RTU to restart.

  3.  
Was this helpful?
What can we do to improve the information ?