Technical FAQs

Ask a Question

Video: How to program an ATV320 for 2 wire control?

Issue:
Programming an Altivar ATV320 for 2 wire control?

Product Line:
Altivar 320, ATV320

Environment:
All

Cause:
Setup, programming.

Resolution:



From main menu,
Enter on dial to go to CONF and enter.
Go down to FULL and enter.
Go down to I_0- and enter.
Set TCC for 2C for 2 wire control.
Set TCT to LEL instead of TRN for level control.
In transition mode, the drive will need to be powered up before a run command is given.
In level mode (LEL), the drive logic DI1 has a state of 0 or 1.  If the run command is given it will run upon power up.
If the run command is not there the drive will wait for one in RDY status.
Was this helpful?
What can we do to improve the information ?