Technical FAQs

Ask a Question

What fine adjustments can be made for the MICROLOGIC P and H trip unit displays using the keypad?

Issue:
What fine adjustments can be made for the MICROLOGIC P and H trip unit displays using the keypad?

Product Line:
Powerpact and Masterpact breakers with Micrologic P or H trip units

Environment:
Electrical distribution

Cause:
Information about fine adjustments

Resolution:
Make fine adjustments using navigation keys or network system management software.
Fine adjustments can only be made for values less than the value set with the switches.
Fine adjustments cannot be set lower than the minimum dial adjustment or higher than the maximum dial adjustment.
Fine switch settings are in the following increments:
  • Longtime pickup 1 amp
  • LT delay .5 seconds
  • Shorttime pickup 10 amps
  • ST delay .1 seconds
  • Instantaineous 10 amps
  • Ground Fault pickup 1 amp
  • GF delay .1 seconds

NOTE:
  • Using switches to set values after making fine adjustments using the keypad will override the keypad adjustments.
  • Fine adjustments are stored in non-volatile memory, so they are retained if trip unit power is interrupted.
Was this helpful?
What can we do to improve the information ?