Technical FAQs

Ask a Question

ATV320: Where is the brake resistor installed?

Issue:
On the ATV320 drives, to what terminals are the Braking resistor connected?

Product line:
ATV320, Altivar 320

Environment:
all

Cause:
Adding braking resistor

Resolution:
On the ATV320 series drives, the braking resistor should connect between terminals PB and PBe.  Also, make sure that parameter BRA (Deceleration Ramp Adaptation) is set to NO.  Factory default for BRA parameter is Yes.  The drive will not use the braking resistor if BRA is set to Yes.  Bra parameter can be found at the following location:  DRI, CONF, FULL, FUN, STT-, BRA.
Was this helpful?
What can we do to improve the information ?