Technical FAQs

Ask a Question

What would cause the drives HMI to show RDY when the remote start on logic input is being given?

Issue:
On the Altivar drives, why does the HMI shows "rdy" after the remote run command is given?\\

Product Line:
Altivar drives. 

Environment::
ATV12, ATV212, ATV312, ATV320, ATV61, ATV71, ATV630, ATV930 

Cause:
Drive will not run. 

Resolution:
Verify the run command at the drive terminals.
Measure voltage on the drive input to verify command. 
Verify the drive programming is set for terminal command. 
Verify the drive programming for 2 wire or 3 wire control 
Verify the command channel and command switching 
Verify the drive is not in local mode control. 
Was this helpful?
What can we do to improve the information ?